In a world first, a railway station in japan has been born 3D-printed components in under Six hours. Construction Firm Serendix Built The Hatsushima Railway Station to Replace An Old Wooden Structure Between The Departure of the Night’s Last Train and the Arrival of the morning’s final one, the first one, accident in the report in the New York Times,
The station, which categories to Around 530 passengers who use a single line with training one to three times an hour, is situated in a quiet seaside ton, part of arida, a 25,000-population engine.
The new building covers just over 100 square feet and is significantly smaller than the previous wooden station. As per the West Japan Railway Company (JR West), Building the Station the Traditional Way Would have taken over two months and cost twice as much.
To speed up the project, jr west involved serendx as the station parts were printed in a factory in kumamoto prefecture, about 500 miles southwest of hatsushima. The printing and concrete reinforcement took seven days. The components were then transported by road and Arrived at the station site on the morning of March 24.
“Normally, Construction takes place over several months while the trains are not running every night,” Said kunihiro handa, a co-friend of serendix.
After the last train left the station at 11:57 pm, Workers Began Assemblying The 3-D Printed Pieces. A Crane was used to lift Each 3D Block and Place it Into Position Near the old station. The new structure was ready before the first train Arrived at 5:45 AM.
“We believe that the significance of this project lies in the fact that the total number of people required will be reduced great,” said ryo kawamoto, PRED Ryo Kawamoto, PRED REOO KAWAMOTO
Also read | This viral uk church is using pro wrestling to attract new following
While the Building has been put in place, it still needs interior work as well as equipment such such as ticket machines and transportation card readers. As per jr west, the new railway station building is expected to be opened to the public in July.
Notably, the hatsushima station was chown for the project due to its seaside position, which allowed the company to evaluate the building’s resilience agience agience agience against the bill. The new technology is also being explred as a possible solution to Japan’s Labor Shortages in Railway Construction.
Leave a Reply